LM6488 User Manual
Twinax Printer Session Configuration
To configure a twinax printer session, follow the initial configuration steps as discussed earlier in this document (Connection Manager, - Configure, - Add, - NLynx Twinax Emulator) and then at the “Twinax” tab type in a Connection Name for the printer (PRINT1 for example), click on the “Printer” button and then select the appropriate printer emulation from the available supported printer emulations, as follows:
|
|
|
|
|
|
Select a unique IBM Host Address, remembering that the IBM Twinax line supports seven station addresses (from 0 to 6) and if you duplicate an address that another device is already using, you will not be able to connect to the IBM host and you may even bring the whole Twinax line down. Select the appropriate “Host Character Set” and “Printing Method” (Direct to Printer Port is default).
The “General” and “ Printer” tabs are
From the “Options” tab you can elect to use the AS/400 printer setup defaults, or deselect
“Defaults” and custom configure the CPI, LPI and Page Scaling options.
From this tab you can also configure “EBCDIC Transparent Mode” and
“EBCDIC to ASCII Translation Pairs” .
Since these two options are dependant upon how the printer application is configured at the IBM Twinax host, you will need to refer to your appropriate IBM administrator for advice and guidance on the relevance of these options to your terminal.
Copyright © | User Manual, | May 19, 2008. | Page 9 |