INTRODUCTION
Thank you for your purchase of the PS16 Personal Monitor Power Center. The PS16 supplies the DC power and distributes the Monitor signal to up to ten of the PM50s, the PM50sOB, and the PM350 units. This dramati- cally increases efficiency and eliminates the need for multiple
The power AND monitor signal are carried from each PS16 output using an ordinary 1/4" stereo cable to the Monitor input of the PM50s, sOB, and
350.Using stereo “Y” adapters, up to ten of the Personal Monitor Amplifi- ers may be
NOTE: Older PM50s and PM50sOB units may need a slight modification in order to operate with the PS16. Any PM50s or PM50sOB WITHOUT a ground lift jumper and mono/stereo jumper will need this modification. Call the factory at (801)
FEATURES
-Supplies power for up to ten PM50s, PM50sOB, and PM350 units.
-Directly supplies a monitor signal to four of the above units, indirectly (by using stereo “Y” adapters) will provide signal for up to ten units.
-Unbalanced 1/4" and
DESCRIPTION
LINE INPUTS
UNBALANCED: 1/4' | ||||||
Monitor or Auxiliary Send. |
|
|
|
|
|
|
BALANCED: Transformer isolated |
|
|
|
|
|
|
|
|
|
|
| 12VAC | |
female XLR jack.Connects to a mixer's |
| unbal |
| balanced |
| |
| LINE INPUTS |
| + | |||
balanced Monitor or Auxiliary Send. |
|
| ||||
|
|
|
|
| - | |
12VAC: Connects to the included Rolls |
| PERSONAL MONITOR | ||||
PS12 power adapter. |
| |||||
| POWER CENTER | PS16 | ||||
|
| |||||
|
| power |
|
|
|
|
OUT 1 - 4: 1/4" |
| status |
|
|
|
|
|
| WARNING: |
|
| ||
The Tip of the connector contains the |
|
| THIS UNIT MAY BE DAMAGED IF THE LIGHT IS OFF | |||
|
| WHEN POWER IS APPLIED - IMMEDIATELY UNPLUG | ||||
|
| ALL OUTPUTS. USE | ||||
audio signal, the Ring has the 12 volts |
|
|
|
|
|
|
DC required to operate the Personal |
|
|
|
|
|
|
Monitor devices, and the Sleeve con- |
|
|
|
|
| www.rolls.com |
|
|
|
|
| ||
nects to ground. |
| OUT 1 |
| OUT 2 | OUT 3 | OUT 4 |
|
|
| ||||
|
|
|
|
|
|
|
CONNECTION / OPERATION
•Connect the Send of the mixer to the appropriate Input of the PS16 (balanced or unbalanced).
•Connect the PS12 adapter to the 12VAC input of the PS16. The Power/ Status LED should light. If not, immediately unplug the power as this indicates a short from the Ring of an Output jack to ground.
•Connect the
FOR APPLICATION DIAGRAMS, VISIT OUR WEBSITE AT WWW.ROLLS.COM.
SPECIFICATIONS |
|
Input Power: | 12 VAC, 700 mA |
Output Power: | 12 VDC on the Ring terminal of each OUT jack. |
Size: | 3.125" x 3.125" x 1.25" |
Weight: | 1 lb (.45 Kg) |
|
|
|
|
|
|
|
|
| SCHEMATIC | |||
|
|
|
|
|
|
|
| PHONE 1/4 |
|
|
|
|
XLR JACK M |
|
|
|
|
|
|
| J1 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
2 |
| T1 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
J11 |
|
|
|
|
|
|
|
|
|
|
|
|
3 |
|
|
|
|
|
|
|
|
|
|
|
|
|
| XFMR AUDIO |
|
|
|
|
| J2 | LOW OUT |
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| PHONE 1/4 |
|
|
| |
1 |
|
|
|
|
|
|
|
|
|
|
|
|
J2 |
|
|
|
|
|
|
| J3 |
|
|
|
|
PHONE 1/4 |
|
|
|
|
|
|
| HIGH OUT |
|
|
| |
|
|
|
|
|
|
|
| PHONE 1/4 |
|
|
| |
|
|
|
|
|
|
|
| J4 |
|
|
|
|
|
|
|
|
|
|
|
| PHONE 1/4 |
|
|
| |
|
|
|
|
|
| U1 |
|
|
|
|
|
|
|
| D4 | 2200UF 16V |
|
| 7812 |
|
|
|
|
|
|
|
| 1 |
|
| 3 |
|
|
|
|
| ||
|
|
|
| I | O |
|
|
|
|
| ||
|
|
|
|
|
| PM SERIES OUTS |
|
|
| |||
|
|
| C17 |
|
| G |
|
|
|
| ||
|
| 1N4001 | R1 |
|
| C7 |
|
|
|
| ||
|
|
|
|
|
|
|
|
| ||||
|
| D1 |
| 4.7K |
|
|
| 1U |
|
|
|
|
IN |
|
|
|
|
| 2 |
|
|
|
|
|
|
| 1N4001 |
|
|
|
|
|
|
|
|
|
| |
J10 |
|
| D5 |
|
|
|
|
|
|
|
| |
| D3 |
| LDRR |
|
|
|
|
|
|
|
| |
| 2 |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
| |
| 3 |
|
|
|
|
|
|
|
|
|
|
|
| 1 | 1N4001 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
JAPDC |
| D2 |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |
|
| 1N4001 |
|
|
|
|
| ROLLS CORPORATION |
|
|
| |
|
|
|
|
|
|
| 5968 S 350 West |
|
|
| ||
|
|
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
| MURRAY UT | 84107 |
|
|
|
|
|
|
|
|
|
| PS16 PM POWER CENTER |
|
|
| ||
|
|
|
|
|
|
|
| Document Number: |
|
| Rev: |
|
|
|
|
|
|
|
| Ba | PS16.SCH |
|
|
| A |
|
|
|
|
|
| Date: | 22 MAY 2002 | Sheet | 1 | of | 1 | |