Rolls RPL108 owner manual Introduction, Operation

INTRODUCTION

Thank you for purchasing the ROLLS RPL108 Power Conditioner and Rack Light. Please read the following owners manual carefully to get the most from this product.

FEATURES:

•Eight switched AC outlets

•Two light modules

Dimmer to adjust light modules brightness

Adjustable swivel and pull-out positioning

The RPL108 protects your delicate electronic equipment by combining a high voltage varistor (MOV) surge and transient suppressor with an RFI/ EMI interference filter. The fast-acting suppression circuit responds in less than a nanosecond, clamping transient voltages to safe levels. The filter works to prevent noise from fluorescent lights, certain dimmers, radio transmitters, and similar sources of "electronic pollution" from contaminat- ing the AC line and from there, leaking into sensitive audio, video, or computer circuits.

OPERATION

MAXIMUM LOAD

The eight circuit breaker protected outlets are rated at 15 amps, which is equivalent to 1800 watts at 120 volts. If the total load on the RPL108 (combining all outlets) exceeds 15 amps, the circuit breaker will trip, cutting off power to your rack. If this happens, reduce the load by unplug- ging one or more units from the RPL108. Then push the circuit breaker button in to reset it.

LAMPS

The RPL108 lamps pull out easily and may be aimed to provide the best illumination for your equipment. Each lamp is supplied with a 7 watt night- light bulb. Replacements are readily available at most hardware stores, or wherever household lightbulbs are sold.

BULB REPLACEMENT

Bulbs are easily replaced without removing the unit from the rack. Simply

unscrew the cap on the end of each light tube, remove the old bulb and replace.

CAUTION - BURN WARNING: The caps and light tubes become hot during normal operation. Avoid burning your fingers by allowing the cap to cool completely before unscrewing it.

Do not push the tubes in while the caps are unscrewed. If you find that the heat from the tubes is excessive, reduce the setting of the Dimmer control, or substitute a 4-Watt bulb.

POWER SWITCHES

The RPL108 has a master POWER switch for the rear outlets as well as the lights. This switch glows when the unit is on.

To turn on the lamps, switch the RACK LIGHTS switch to the ON position, and adjust the DIMMER control for the desired brightness. The lights do not turn off automatically when the tubes are pushed in, so be sure to switch the RACK LIGHTS switch to the OFF position before pushing in the tubes.

R A C K L ID GI MH TM SE R			R E S E T	P O W E R
			O N
O N
	R P L 1 0 8
O F F	P O W E R C O N D I T I O N E R A N D R A			L I G H T
M I N M A X		1 8 0 0 W A T T S M A X	O F
	P U L L
		P U L L	R E A R O U T P U T S

	M A X I M U M	L O A D : S W I T C H ERISQUED DEOCHOCU T- NELPASEENLEVERT S WARNING1 2 0:VDO NOTA CEXPOSE, THIS1 5EQUIPMENTA , TO1RAIN8 0CAUTION:0 W TOA REDUCET T THES RISK OF ELECTRIC SHOCK DO NOT NOT REMOVE BACK.
A C I N			OR MOISTURE.	NO USER SERVICABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

1 2 0 V A C , 1 5 A , 6 0 H z	A V I S : R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R
M O D E L R P L 1 0 8