Planet Technology ADE-3000 user manual Physical Details, Front Panel, Rear Panel

Introduction

Physical Details

Front Panel

The front panel of ADE-3000 has 2 LEDs for one LAN port and one ADSL port. Figure 2 displays a front panel of the router.

	Figure 1-2: Front Panel
LED definitions
Status ADSL	On – ADSL LED status will be on after chaining procedure
	with DSLAM is completed
Status LAN	On –LAN LED will be on while RJ-45 connector is plugged
	in.

Rear Panel

Figure 1-3: Rear Panel

Button definition

Reset Button

This button has two (2) functions:

∙When pressed and released, ADE-3000 will reboot (restart).

∙When reset button is pressed over 5 seconds and then release. ALL data will be clear and restore ALL settings to the factory default values.

Restore Default IP Address and Clear Password

If ADE-3000's IP Address or password is lost, the following procedure can be used to recover from this situation.

Pressing the Reset button for more than 5 seconds. ADE-3000 will restore to factory default setting. Note that this should be done only when you had tried all the troubleshooting options. Pressing the Reset button during operation may bring you into the risk of creating IP address conflict between your PC and the router. In such a case, you may be compelled to reboot your entire system(s).

3

PDF created with FinePrint pdfFactory Pro trial version http://www.fineprint.com