Technicolor - Thomson CS606 Getting Started, EN Content of Box Connections of Antennas, Speakers

CS606_EN 6/12/06 2:08 PM Page 10

Getting Started

Getting Started

EN Content of Box		Connections of Antennas and
•	one main unit (with 2 main speakers);	Speakers
•	one remote control;
• one MW loop antenna;
•	one user’s guide;
•	Guarantee card

Using the FM and MW Antennas

Before you use your audio system, you’ll want to make sure both the FM and MW antennas are positioned properly. Uncoil the FM antenna at the back of the unit, making sure it is fully extended (you may even want to tape it to the wall behind the unit if possible. The higher the better.) You’ll also need to connect the MW antenna loop to the back of the unit if you listen to MW stations. Rotate the MW loop antenna for better reception.

Installation EN

To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:

	10cm
10cm	Front View	10cm

!

Warning:

Use of this product is for your personal use only. Unauthorized recording or duplication of copyrighted material may infringe upon the rights of third parties and may be contrary to copyright laws.

3

4

1

2

Connecting the Speakers

Each speaker has a black (negative) and a red (positive) jack. When connecting the speakers, match the red wires to the red jacks and the black wires to the black jacks.

Speaker Wire Connection

10cm

5cm

Note:

Make sure the tracks are encoded in mp3 or Windows Media formats and supported bitrates. Bitrates supported by the player:

mp3 – 32 to 320kbps wma – 48 to 160kbps

1.FM Antenna.

2.Main Speaker Jacks.

3.MW Loop antenna Jacks.

4.AUX IN

Side View

Push Speaker terminal tab	Release tab to lock wire in
down to insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.

3 4