Samsung AH68-01493X Auto Sound Calibration, Connect the ASC Place the ASC Microphone to ASC

Auto Sound Calibration

By setting the ASC function just once, the speaker distance, channel level and rear sound reflection effect are automatically set and create an optimal listening environment.

• This function works only in DVD/CD function.

•If you install the speaker as the RRSS speaker, make sure to install the rear speaker toward the side wall so that rear speaker sounds of the front/rear speaker (left/right) are reflected against the wall.

Connect the ASC	Place the ASC
Microphone to ASC	Microphone at the
1input connector.	2 listening position.

Press the ASC	When “REMOVE
	MIC” appears on the
3 button.	4 display, disconnect
	the ASC microphone.

•A speaker tone will be output from L ➝ R after signal sound is output

one time in the order of

L ➝ C ➝ R ➝ RS ➝ LS ➝ SW.

•An optimal listening environment will be set up automatically

• It takes about 3~4 minutes to complete the ASC setup.

Signal sound is output

Setting is complete after piano

sound is output.

Note • If you are instaling the system for the first time, “NO MEASURED DATA” will appear on the display when you press the ASC button while the ASC Microphone is not connected.

67

•

•

During the Auto Sound Calibration setup, the speaker tone's output volume is fixed. You cannot use the volume buttons to adjust the output level.

If you remove the ASC Microphone during ASC setup, the setting will be cancelled.