Power Acoustik Radio Troubleshooting: How to Reset, Fix Bluetooth Issues, and More

TROUBLESHOOTING

	Symptom	Cause	Remedy
	Power does not turn		Replace with fuse of the same amperage.
	on.	Fuse is blown	If the fuse blows again, consult your store
	(No sound is		of purchase
	produced.)	In correct wiring	Consult your local retailer.
			1. Turn off the unit.
			2. Remove all wires attached to the
		Power antennal	power antenna lead. Check each wire
			for a possible short to ground using an
	No sound output	lead is shorted to
			ohm meter.
	when operating the	ground excessive
			3. Turn on the unit.
	unit with amplifiers	current is required
General			4. Reconnect each amplifier remote wire
	or power antenna	antenna.
			If the amplifiers turn off before all wires
		or remote on the	to the power antenna lead one by one.
	attached.	amplifiers or power
			are attached, use an external replay to
			provide remote-on voltage (excessive
			current required).
	Nothing happens	The microprocessor	Turn off the power, Then press the [no
	when buttons are	has malfunctioned	open] button and remove the DCP. Press
	pressed.	due to noise, etc.	the reset button for about 2 seconds with
	Display is not		a thin rod.
	Accurate
		Panel or main unit	Wipe the dirt off with a soft cloth
		Connectors
			moistened with cleaning alcohol.
		are dirty
		Compact disc is	Clean the compact disc without scratches
	Sound is bad directly	dirty
	after power is turned	Compact disc is	Replace with a compact disc without
	on.	heavily scratched
			scratches.
CD		or warped
		Water droplets may
	Sound is bad directly	form on the internal	Let it dry for about 1 hour with the power
	after power is turned	lens when the car is
			on.
	on.	parked in a humid
		place
		When deck
		mechanism error, it	Reset the unit.
		show ERROR 1
LCD		When disc or servo
	Small LCD display	error, it show	Change the disc or reset the unit.
	error massage	ERROR 2
		When USB error, it	1.Remove the USB/SD and insert it again
		show ERROR 3
			2. File error，please check the file.
		When SD error, it
			3.Reset the unit.
		show ERROR 4

23