Renesas EDK3687 user manual Table of Contents

Page 3

1.TABLE OF CONTENTS

1.	TABLE OF CONTENTS	3
2.	START-UPINSTRUCTIONS	4
2.1.	INSTALLING THE EVALUATION DEVELOPMENT KIT (EDK)	4
2.2.	SERIAL CONNECTION	4
2.3.	POWER SUPPLY	4
3.	EDK BOARD LAYOUT	5
3.1.	EDK BLOCK DIAGRAM	5
4.	EDK OPERATION	6
4.1.	USER INTERFACE	6
4.2.	SERIAL INTERFACE	6
4.3.	SPI EEPROM	7
4.4.	I2C EEPROM	8
4.5.	LIN INTERFACE	8
4.6.	LEDS	8
5.	BOARD OPTIONS	9
5.1.	JUMPER LINKS	9
5.2.	EDK OPTIONS – CJ4	10
5.3.	OPTION LINK SELECTION	11
5.4.	FLASH PROGRAMMING HEADER	12
5.5.	EXTERNAL DEBUG HEADER	12
5.6.	BOOT CONTROL	12
6.	MICROCONTROLLER HEADER CONNECTIONS	13
6.1.	HEADER J1	13
6.2.	HEADER J2	13
7.	CODE DEVELOPMENT	14
7.1.	HMON	14
7.2.	ADDITIONAL INFORMATION	16

3

Image 3

Contents EDK3687 Preface Table of Contents Serial Connection Installing the Evaluation Development KIT EDKPower Supply START-UP InstructionsEDK Board Layout EDK Block DiagramEDK Operation Connector PIN DefinitionsSignal Host DB9 Connector Pin User InterfaceSPI Eeprom Crystal ChoiceRemovable Component Information Pin I2C EepromLIN Interface Port MicrocontrollerJumper Links Board OptionsEDK Options CJ4 RST Reset Function LIN LIN InterfaceOption Link Selection Can Controller Area Network Boot ControlExternal Debug Header SPI Serial Peripheral InterfaceMicrocontroller Header Connections Pin Function EDK Symbol DeviceCode Development Code Located in Flash / ROMChmon Memory MAPAdditional Information Baud Rate Setting Interrupt Mask Sections