Planet Technology EV-401S, EV-401M user manual Trouble Shooting, Checkpoint

Page 21

5.TROUBLE SHOOTING

SYMPTOM: VDSL link LED not lit after wire is connected to the VDSL port.

CHECKPOINT:

1:Verify the length of the wire connected between EV-401M and EV-401S is not more than 1.5km.

2:Please note you must use 1 EV-401M and 1 EV-401S connect to each other to make it work.

SYMPTOM: Switch Link/Act LED not lit after cable is connected

to the port.

CHECKPOINT:

1:Verify use the RJ-45 cable connected to the port.

2:If your device(like Lan card) support to Auto-Negotiation, please try to manual set at a fixed speed of your device to solve this problem.

EV-401M / EV-401S User's Manual

21

Image 21

Contents EV-401M / EV-401S User’s Manual Part No. EM-EV401V1 RevisionTable of Contents This page intentionally left blank Checklist Check the contents of your package for following partsIntroduction General Description Introduction To Ethernet over Vdsl ConverterMulti-Port Master Converter provides the following key features Key FeaturesMDI/MDI-X SpecificationsThis page intentionally left blank Hardware Description Front PanelEV-401M front panel EV-401S front panel LED indicators Rear panel of the Converter is shown as below Rear PanelPower Notice Phone line wire diameter Distance Install the Ethernet Over Vdsl ConverterConnect to Multi-Port Master LAN to LAN connectionStation Connections with Telephone Wires Installing Network CablesThis page intentionally left blank MAC Address Table and Learning Switch OperationFiltering and Forwarding Store and ForwardThis page intentionally left blank Checkpoint Trouble ShootingPage EM-EV401V1 ISO9002