Sonance installation instructions VE1 and VE2, Visible and Dual Visible IR Emitter

INSTALLATION INSTRUCTIONS

VE1 AND VE2

VISIBLE AND DUAL VISIBLE IR EMITTER

DESCRIPTION

The VE1 Single and the VE2 Dual Visible Emitters each contain a small Infrared LED, housed in a small plastic shell. Unlike other emitters, they emit visible red light in addition to IR (infrared) control signals when activated by IR commands sent to them by IR receivers or other Sonance controllers. They are designed to be installed directly on the IR sensor window of each controlled device.

VE2 Dual Visible IR Emitter

7 FT 3 FT

3.5 mm mono	VE1 Visible IR Emitter
mini plug

5/8"

5/16"

INSTALLATION

ATTACHING THE EMITTERS TO IR SENSOR WINDOWS

•Each emitter has a clear adhesive layer on the bottom flat surface of the shell. The rounded side faces the user and emits visible red light when a command is sent.

•Simply peel off the protective cover and affix the emitter to the center of the IR sensor window on the controlled component's front panel. Move the emitter back and forth in front of the window while sending codes to find the best location. A foil-packed alcohol swab has been included for your convenience. Use the swab to clean off the IR sensor window before adhering the IR emitter(s) or to clean the IR emitter(s) after installation.

•In some cases it may be difficult to find the location of the IR sensor on the component. Consult the owner's manual of the unit, or the manufacturer, for the exact IR

window location.

•Double-sided adhesive tape is included. If you move the emitter to a different component, use this tape to replace the current adhesive layer.

•The shell is transparent to infrared light, allowing commands from a handheld remote control to pass through the shell. This permits direct control of the equipment from a handheld remote as well as with the VE1 or VE2.

Pg1