4. XLR Inputs
If your preampliÞer has XLR outputs, connect them to these XLR inputs. These balanced connections offer superior noise rejection com- pared to the unbalanced RCA inputs.
The female XLR inputs are wired as follows:
Pin 1 is ground
Pin 2 is positive (hot)
Pin 3 is negative (cold)
Balanced connections pass the input signal along two conductors. If there is any external noise and inter- ference passing into the audio lines, both conductors will receive the same amount of noise. This noise is then rejected in the balanced input stage of the Cinema Grand AmpliÞer.
5.Current Source Outputs and:
6.Voltage Source Outputs
The front left and front right chan- nels each have a Voltage Source output and a Current Source output. The remaining channels have Voltage Source outputs only.
The Voltage Source outputs have
asource impedance of approximately zero ohms. The Current Source outputs have a source impedance of approximately one ohm.
The top post of each binding post pair is the positive output, and con- nects to the positive (red) post of your speaker. The bottom post of each pair is the negative, and connects to the negative (black) post of your speaker. The posts can accept bare wire, spade terminals, and dual or single banana connectors.
+ | + |
- | - |
|
CHAPTER 1
NOTE: The Current Source output is a Voltage Source modiÞed to yield an impedance of one ohm. This cor- responds approximately to a vacuum tube ampliÞer's output impedance and constitutes the dominant factor in the soundstage delivery of classic vacuum tube power ampliÞers.
7. Current Source Fuses
Each Current Source output has an
8. IEC connector
The ampliÞer comes with a detach- able Linecord which attaches here. Make sure it is Þrmly pushed in place. Connect the other end to an AC outlet which is properly conÞgured for the type of plug and has the correct volt- age for your model.
9. AC Line fuse
If this fuse fails, replace it with the exact same type and current rating.
Note: Always unplug the power cord from your AC
Bare Wire | Spade |
+ | - | + | - | Banana | |
|
|
|
|
According to your musical taste, you may select the Current Source for driving electrostatic, planar magnetic or ribbon speakers. Select the Volt- age Source for driving subwoofers. For cone based systems, use either. For a biwired system, use the Current Source for midrange and treble driv- ers, and use the Voltage Source for the subwoofer(s). These are sugges- tions only. By all means, please feel free to experiment with other wiring options. (See page 14.)
User's Manual
outlet before removing the fuse.
With a ßat ended screwdriver, push the fuse carrier in slightly and turn it
9