UC343FH 10/23/03 2:32 PM Page 5
CONNECTING THE POWER CORDS
We recommend connecting the power lead to the Ignition Switch Accessory Terminal. This way, the transceiver is automatically turned off when the ignition switch is turned off.
Or, the power cord may be connected to an available terminal on the fuse block, or, to a point in the wiring harness. However, caution must be taken to prevent a short circuit. If in doubt, contact your vehicle dealer for information.
This transceiver may be installed and used in any
GROUND INFORMATION
Most newer U.S. and foreign made cars, and small trucks, use a negative ground system. Some older cars, and some new large trucks, use a positive ground system.
With a negative ground system, the negative
Negative Ground System
If you have a negative ground system, connect the red DC power cord from the transceiver to the positive (+) battery terminal or other convenient point. Then connect the black power cord to the vehicle chassis or negative
Positive Ground System
If you have a positive ground system,connect the black DC power cord from the transceiver to the negative
5