SMC Networks SMC8036TX Troubleshooting, Be sure the network cable is connected to both devices

Page 17

TROUBLESHOOTING

TROUBLESHOOTING

Symptom

Link LED does not light after connection is made.

Probable Causes

10BASE-T/100BASE-TX hub port, network card or cable may be defective.

Possible Solutions

•Check that the host computer and hub are both powered on.

•Be sure the network cable is connected to both devices.

•Verify that Category 5 cable is used if you are operating at 100 Mbps and that its length does not exceed 100 m (328 ft).

•Check the network card connections for defects.

•Replace the defective cable if necessary.

7

Page 16 Page 18
Image 17
Page 16 Page 18
Contents EZ CardBus 10/100 Page EZ Switch 10/100 User Guide Trademarks CopyrightLimited Warranty Limited Warranty FCC Class B Certification CompliancesEC Conformance Declaration Class B Table of Contents Table of Contents About EZ Cardbus 10/100LED LED IndicatorsFeatures and Benefits Instructions Installing the CardEquipment Checklist Installing the Drivers Diagnostics Program Be sure the network cable is connected to both devices TroubleshootingStandards SpecificationsCompliances Specifications Page Internet
Top Page Image Contents