Soho FSD-800 user manual 10Mbps Hub to 100Mbps Hub, Mbps File server to Hubs Connection

Page 13

Uplink

Figure 3. 100Mbps File server to Hubs Connection

10Mbps Hub to 100Mbps Hub

Plug one end of the Category 5 UTP Cable into one port of the Switch, and the other end of this cable into “Uplink” port of the 100Mbps Fast Ethernet Hub. The cable length between these 2 connecting points should not exceed 100 meters.

Plug one end of the Category 3 UTP Cable into one port of the Switch, and the other end of this cable into “Uplink” port of the 10Mbps Ethernet Hub. The cable length between these 2 connecting points should not exceed 100 meters.

FSD-800 User's Manual

9

Image 13

Contents SOHOConnect Series Revision Table of Contents This page is intentionally left blank Introduction ChecklistChapter SOHOConnect Series Features SOHOConnect Series Front Panel Hardware DescriptionRear Panel LED indicatorsMake sure the wiring is correct Hardware Installation100Mbps Server to 10Mbps Hub ConfigurationMbps File server to Hubs Connection 10Mbps Hub to 100Mbps HubAddress Table Switch OperationLearning Forwarding & FilteringStore-and-Forward Auto-Negotiation If attached device is 100Base-TX port will set to This page is intentionally left blank Troubleshooting SOHOConnect Series Appendix a SpecificationsPerformance