MOON PSX 5.3 Power Supply
LP 5.3 Internal Settings
A B A B
Figure 1: MOON LP5.3 Circuit Board layout
Prior to connecting your MOON LP 5.3 Phono Preamplifier to the MOON PSX 5.3 Power Supply, you must move two
(2)internal jumpers inside your MOON LP 5.3. Please refer to page 8 of your MOON LP5.3 owner’s manual for detailed instructions on how to remove the chassis cover. Referring to the above diagram of the LP5.3, you will see an array of four
(4)jumper sockets labeled STR1, STR2, STR3 and STR4. The factory default position for the 2 jumpers is in sockets STR2 and STR4 (positions B in figure 1). To properly operate the MOON LP 5.3 in conjunction with the MOON PSX 5.3, you will need to move these 2 jumpers into sockets STR1 and STR3 (positions A in figure 1). Failure to make these adjustments may cause damage that is not covered by warranty.
____________________________________________________________________________________
LP 5.3 Internal Settings | 7 |