SECO-LARM USA EVT-RBP-GNCQ* installation manual Range Up to 450’ 137m over STP cable, What it is

ENFORCER VGA BALUN

Trouble Shooting:

Problem	Possible Cause	Possible Solution
Wavy or ghost image if	a. Strong electromagnetic	a. Move the cable away from possible sources of
connected to image processor	interference.	interference.
(e.g., multiplexer or DVR), but	b. Split pairs.	b. Ensure same twisted pair connects to balun at both ends
not if directly to monitor?	c. Crimped cable.	of cable.
		c. Replace cable with new cable.
Image background flutters	Interference from external	Remove power source, or adjust monitor's brightness and
between dark and light?	power source.	contrast.
Image is weak or faded?	a. Exceeded recommended balun	a. Reduce cable length.
	separation.	b. Replace with a higher-grade cable. CAT 5 cable meets
	b. Using lower-grade cable than	specifications in the manual. CAT 5E or better cable
	recommended.	allows longer range.
No image?	a. Power is off.	a. Check the power supplies of all devices connected to the
	b. Cable is incorrectly	cable.
	connected/crimped.	b. Double-check that the cable was connected and crimped
	c. Cable was accidentally cut.	properly.
	d. Defective video source.	c. Run a continuity test on all wires in the cable.
	e. Defective video destination.	d. Replace the unit with a new unit.
		e. Replace the unit with a new unit.

Installation Manual

ENFORCER®

Passive VGA Baluns

EVT-SBP-GQ

VGA Balun Set

EVT-TBP-GCNQ*

TX / PC / Source Side

EVT-RBP-GNCQ*

RX / Monitor / Destination Side

Range: Up to 450’ (137m) over STP cable

*Note: SECO-LARM Passive VGA Baluns are sold as a set only.

ENFORCER VGA BALUN

CA-1D1DQ Gender Changer.

Allows EVT-RBP-GNCQ to connect to certain CRT monitor cables. Product sold separately

IMPORTANT: Users and installers of this product are responsible for ensuring this product complies with all national, state, and local laws and statutes related to monitoring and recording audio and video signals. SECO-LARMwill not be held responsible for the use of this product in violation of any current laws or statutes.

WARNING: Incorrect mounting which leads to exposure to rain or moisture inside the enclosure could cause a dangerous electric shock, damage the device, and void the warranty. Do not open the case of this device, as there are no field-serviceable components inside.

WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for a period of one (1) year from the date of sale to the original consumer customer. SECO-LARM’s obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse, neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser’s exclusive remedy, shall be limited to replacement or repair only, at SECO-LARM’s option. In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else.

NOTICE: The information and specifications printed in this manual are current at the time of publication. However, the SECO-LARM policy is one of continual development and improvement. For this reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also not responsible for misprints or typographical errors.

Copyright © 2007 SECO-LARM U.S.A., Inc. All rights reserved. This material may not be reproduced or copied, in whole or in part, without the written permission of SECO-LARM.

SECO-LARM®U.S.A., Inc., 16842 Millikan Avenue, Irvine, CA 92606		® PITLW2
Tel: 800-662-0800 / 949-261-2999 Fax: 949-261-7326	Website: www.seco-larm.com	MiEVTSBP-GQ.pmd
	E-mail: sales@seco-larm.com	Page 4

The model numbers EVT-TBP-GCNQ (transmitter / PC / source side) and EVT-RBP-GNCQ (receiver / monitor / destination side) are provided for identification purposes only.

What it is:

VGA baluns allow extension of the range between CCTV video sources such as PCs, digital video recorders, or video splitters, and CCTV video destinations such as CRT / LCD monitors or video projectors. The range is up to

450feet (137m). The connection is via low-cost Cat 5 or Cat 5E shielded twisted-pair (STP) cable with shielded RJ-45 connectors. This allows the monitor or projector to be easily installed on a security professional's desk while the video devices are locked securely in a separate room.

Features:

Note: For some CRT monitors, a gender changer may be required. The CA-1D1DQ is designed to connect the EVT-RBP-GNCQ to the CRT monitor cable.

● Passive operation -- No power required.

● Sends a VGA video signal from a VGA source (personal computer, digital video recorder, video splitter, or other video source) to a VGA destination (CRT monitor, LCD monitor, or VGA projector).

● Uses Cat 5 or Cat 5E shielded twisted pair (STP) cable instead of heavier, more expensive VGA cables. ● Works at the following resolutions and maximum distances:

640x480	(VGA)	450ft (137m)
800x600	(SVGA)	350ft (107m)
1024x768 (XGA)		250ft (76m)
1280x1024 (SXGA)		200ft (61m)

● Small size, only 21/8" x 13/16" x 1" (55 x 30 x 26 mm) with a 6" (152mm) pigtail for the VGA connector. ● The EVT-SBP-GQ is sold as a set - one for the source side, one for the monitor side.