INSTRUCTIONS
1)Connect the supplied cable from the HDTV HDMI sources into the 1x4 HDMI Splitter input. HDMI to HDMI cable for HDMI source or HDMI to DVI cable for DVI source.
2)Connect the cables from your displays (monitor or projector) into the HDMI outs of the 1x4 HDMI Splitter.
3)Plug the 5VDC power supply into the 1x4 HDMI Splitter.
DIP SWITCH GUIDELINES
Inside the HDMI1X4 is a bank of Dip Switches. Below is a table describing their functions. By default, all switches are set to the Off position.
Dip Switch # | Name |
1 | Switching Delay |
2 | On Board EDID |
3 | IR Code Dip Switch |
4 | IR Code Dip Switch |
5 | Unused |
6 | Unused |
7 | Unused |
8 | Edge Select |
Description
Adds a 3 second delay to switching
Feeds a generic HDMI EDID (720p/1080i) to all inputs Corresponds to Dip Switch 1 on
-
-
-
+ Edge Pixels
How to open the 1x4 HDMI Splitter:
To access the dip switches, just remove the four screws on the bottom. Slide the top portion off of the bottom and you should see the dip switches on the board.
- 3 -