Seagate ST4000VM000 manual Power specifications, Power consumption

Page 15

www.seagate.com

Drive Specifications

2.8Power specifications

The drive receives DC power (+5V or +12V) through a native SATA power connector. (Refer to Figure 3 ).

2.8.1 Power consumption

Power requirements for the drives are listed in Table 2 on page 15. Typical power measurements are based on an average of drives tested, under nominal conditions, using 5.0V and 12.0V input voltage at 25°C ambient temperature.

• Spinup power

Spinup power is measured from the time of power-on to the time that the drive spindle reaches operating speed.

• Read/write power and current

Read/write power is measured with the heads on track, based on a 16-sector write followed by a 32-ms delay, then a 16-sector read followed by a 32-ms delay.

• Operating power and current (CE profile)

Operating power is measured by simulating a typical PVR operating environment, using a 50% write, 50% read algorithm.

• Idle mode power

Idle mode power is measured with the drive up to speed, with servo electronics active and with the heads in a random track location.

• Standby mode

During Standby mode, the drive accepts commands, but the drive is not spinning, and the servo and read/ write electronics are in power-down mode.

Table 2 DC power requirements for 2TB models

Power dissipation (2-disk values shown)

Avg (watts 25°C)

Avg 5V typ amps

Avg 12V typ amps

 

 

 

 

Spinup

2.0

 

 

 

 

Idle* †

3.7418

0.221

0.219

 

 

 

 

Operating

5.05

0.302

0.295

 

 

 

 

Standby

0.819

0.15

0.005

 

 

 

 

Sleep

0.819

0.15

0.005

 

 

 

 

*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels.

†5W IDLE, Standby and Sleep,with DIPLM enabled

Table 3 DC power requirements for 1TB models

Power dissipation (1-disk values shown)

Avg (watts 25°C)

Avg 5V typ amps

Avg 12V typ amps

 

 

 

 

Spinup

2.0

 

 

 

 

Idle* †

2.502

0.152

0.145

 

 

 

 

Operating

3.676

0.385

0.145

 

 

 

 

Standby

0.819

0.15

0.005

 

 

 

 

Sleep

0.819

0.15

0.005

 

 

 

 

*During periods of drive idle, some offline activity may occur according to the S.M.A.R.T. specification, which may increase acoustic and power to operational levels. Measurement was taken in Idle 1 mode.

†5W IDLE, Standby and Sleep,with DIPLM enabled

Video 3.5 HDD Product Manual, Rev. H

15

Image 15
Contents Video 3.5 HDD Revision Date Description of changes Document Revision HistoryContents Video 3.5 HDD Product Manual, Rev. H Figures Video 3.5 HDD Product Manual, Rev. H Seagate Technology Support Services Video 3.5 HDD Product Manual, Rev. H About the Serial ATA Interface IntroductionIntroduction Drive Specification ST2000VM003 ST1000VM002 Specification summary tablesDrive Specifications Recording and interface technology LBA modeDefault logical geometry Formatted capacityTypical seek times ms Read Write Physical characteristicsSeek time Start/stop timesPower consumption Power specificationsTypical Current Profiles Voltage tolerance Power-management modesPower modes Heads Spindle Buffer Conducted noiseAltitude Environmental specifications Drive case temperatureTemperature gradient HumidityVibration ShockModel Idle Seek ST2000VM003 AcousticsTest for Prominent Discrete Tones PDTs Electromagnetic immunityElectromagnetic compatibility WarrantyAgency certification Safety certification Reliability Annualized Failure RateAustralian C-Tick N176 FCC verificationEnvironmental protection China Restriction of Hazardous Substances RoHS DirectiveCorrosive environment Drive Specifications Handling and static-discharge precautions Configuring the driveSerial ATA cables and connectors Attaching Sata cabling Drive mountingMounting dimensions 2TB model Mounting dimensions 1TB model Segment Pin Function Definition Serial ATA InterfaceSupported ATA commands Command name Command code in hexE5H E3H E7HEAH ECHF1H F3HF4H F5HWord Description Value Identify Device commandXxxxH Fffeh BE01HBit Word Ultra DMA mode 6 is supported Set Features commandCode in features register A.R.T. command A.R.T. commandsEprml IndexVideo 3.5 HDD Product Manual, Rev. H Video 3.5 HDD Product Manual, Rev. H Video 3.5 HDD Product Manual, Rev. H Page Americas Seagate Technology LLC