DSP(Digital Signal Processor) Modes
DSP modes have been designed to simulate different acoustic environments.
The sound heard in a hall, theater, pavilion, dance club, or live club consists of direct and indirect sound — early reflections and reflections from behind.
To increase Effect level
Direct sounds reach the listener directly without any reflection.
Indirect sounds are delayed by the distance of the ceiling and walls.
These indirect sounds are an important element of the acoustic surround effect.
Press the DSP/DPLII Mode button.
• This function works only in the STEREO Mode.
•The following DSP modes are provided with this unit:
➠HALL Provides a clear vocal and simulates the feeling of a concert hall.
➠
To increase Effect level
Press the DSP/DPL II Effect button.
•The effect level can be set in steps from 1 to 4 EFFECT1 ➔ EFFECT2 ➔ EFFECT3 ➔ OFF(DEFAULT).
Each time the button is pressed the selection moves to the next effect.
•The higher the number, the stronger the DSP surround effect will be.
• This function works only in the DSP Mode.
Effect
What is a Effect?
This sets the strength of the DSP mode.
THEATER Simulates the feeling of a theater.
➠
PAVILION Simulates the spacious feeling of a pavilion with a high ceiling.
➠
DANCE CLUB Simulates the sound of a dance club with a throbbing bass beat.
➠
LIVE CLUB Simulates the feeling of a live music club with a low ceiling.
• These DSP modes can be used to add acoustic surround effects while reproducing |
stereo analog or linear PCM digital signals. |
Adjusting DSP Sound Parameters
You can
1
Press the DSP/DPL II Mode button.
• When one of the DSP modes is selected,the DSP indicator lights up on the display. |
DSP modes available according to the input signal format
O : Possible, X : Not possible |
2
Press the Sound Edit button.
•Each time you press the button, the indication on the display changes as follows:
00 F 00 | 00 R 00 | REAR | SW |
Normal | REVERB | LIVE | ROOM |
indication |
|
|
|
(canceled) |
|
|
|
ROOM : To adjust the resonance based on the room size. The larger this value is, the more effective the resonance is (from 04 to 16 by 2 steps).
LIVE (Liveness) : To adjust the liveness. The larger this value is, the more liveness is obtained (from 04 to 16 by 2 steps).
REVERB (Reverberation) : To adjust the reverberation time of the sound (from 0.0 msec to 1.6 msec by 0.2 msec steps).
3
Press the Left/Right (▲ | / | ▲) button to |
adjust the DSP sound parameter.
39
• This function works only in the DSP Mode. | 40 |