Wyse Technology X90LE manual Removing the RAM module

Page 12

6

7.Install the new flash module in the reverse order of removing the old module.

8.To remove the existing RAM module, use your fingers to unlock the two locking clamps at either side of the module by pushing the clamps in the direction of the arrows shown in Figure 9. The module should pop up from its socket. Lift out the RAM module.

Note

Early 1-GB configurations had two (2) 512-MB DIMMs installed. Your mobile thin client may or may not have a RAM module installed in this location; if it does, then replace with one (1) 1-GB RAM module.

Figure 9 Removing the RAM module

9.Insert the new RAM module into the connector of the original module, and then press down on the module so that the two locks will snap in place, securing the module.

10.Replace the cover and keyboard in the reverse order as shown in Figures 5 through 7.

11.Proceed to “Verifying the Mobile Thin Client’s Operation.”

Image 12
Contents Installation Guide Copyright Notice Iii This page intentionally blank Contents ViContents This page intentionally blank About this Guide Wyse Technical SupportKit Warranty Getting StartedRequired Tools and Materials Installing the Upgrade Kit Unsnapping the switch coversLifting up keyboard Removing the RAM module Verifying the Mobile Thin Client’s Operation Closing the WinPing windowShutting down from the XPE Test window Client Information Attaching the Upgrade Serial Label Attaching the Upgrade Serial LabelFigures