Model MRK-103F
Step 5
5-1. Slide the carrier body back into the cartridge frame. (Fig.7)
Fig. 7
5-2. Push carrier body further into cartridge frame until fully inserted. (Fig. 8)
Fig. 8
Step 6
6-1. Install the module into a 5.25” half-height expansion bay. Insert the DC power cable and the IDE cable of the user’s chassis to connectors located at the back plane of the cartridge frame. Then, fully secure the module to the chassis by using the four M3x6 screws provided. (Fig.9)
Fig. 9
6-2. Pull the active-handle outwards and use the miniature key turning the key clockwise to secure the handle. (Refer to
provided and insert into the key hole, section 2-2 Key lock)
Copyright 2002 Vantec Thermal Technologies, INC. All Rights Reserved http://www.vantecusa.com
