POWER OPTION ONE - 6V DP TM POWER CLIP
(4 AA BATTERIES NOT INCLUDED)
1. Unscrew Power Clip cover screw and remove cover. Insert 4 AA batteries, with polarity
2. Release battery compartment latch.
3.Insert Power Clip into battery
compartment and slide Power Clip away from latch.
4.
5.
Make sure Power Clip snaps securely in place, turn battery compartment latch and lock Power Clip in place.
To remove Power Clip, turn latch, slide Power Clip toward latch and lift out.
IMPORTANT BATTERY INFORMATION
■Insure that battery polarity is correct.
■Use only batteries of the type recommended (or equivalent).
■Do not mix old and new batteries.
■Do not mix alkaline, standard
■Remove
■For best performance use alkaline batteries. Battery life may vary depending on battery brand. Toy performance may decrease as batteries weaken.
■Do not recharge
■Do not
■Remove rechargeable batteries before recharging.
■Recharge batteries only under adult supervision.
■Dispose of batteries safely.
Battery Contacts
■Bent or dirty contacts may result in loss of power.
■If battery does not fit correctly, gently bend back metal contact as shown in diagram.
metal contact
NOTE: The batteries used in the 6V DP Power Clip will gradually lose power over their lifetime. You will notice a decrease in performance as this occurs. The 6.0V Jet Turbo rechargeable NiCd battery pack will run at a sustained high power level for virtually its entire run time.
POWER OPTION TWO - 6.0V JET TURBO ® RECHARGEABLE NiCd BATTERY PACK
Please read Battery Charging/Care
on the next page.
1.Release battery compartment latch.
2.Insert battery pack into battery compartment and slide battery pack away from latch.
3.Make sure battery pack snaps securely in place, turn battery compartment latch and lock battery pack in place.
4.To remove battery pack, turn latch, slide battery pack toward latch and lift out.
TRANSMITTER
1.Slide battery door open.
2.Install one
3.Replace battery door.