Olicom 2 quick start Memory Configuration Table, Configure Memory

Hardware Installation

SY-P4I865PE Lite DRAGON 2 Quick Start Guide

Configure Memory

This motherboard supports one Dual Channel to your memory. Note that you can use normal DDR memory for Dual Channel to work. Also note that for Dual Channel to work 2 modules of equal size and specifications have to be installed.

The largest memory capacity possible is 3GB. On this motherboard, DRAM speed can be set independent from the CPU front side bus speed. Note that when installing 3GB of memory, your total memory will be less than 3GB. The reason for this is that the BIOS, PCI and AGP cards claim part of your CPUs address space.

Memory Configuration Table

If you want to use the Dual Channel feature, please follow the memory configuration table below:

DDR

Slots DDR_A1 DDR_A2 DDR_B1

Performance

128 bit Present Present

Installing your memory in a combination different from the table above will still allow your system to work. The Dual Channel feature will not work then however.

Check page5 (motherboard layout) for more info on the location of A1 & B1 DIMM slot.

Memory frequency Table

Depending on the front side bus (FSB) frequency of the CPU, you can run memory of different speeds. Please look at the table below for details:

CPU FSB (MHz)	Memory Frequency	DDR DIMM Type
	(MHz)
400	266	PC2100
533	266 or 333	PC2100 or PC2700
800	400 or 320*	PC3200 or PC2700

*When using a 800 MHz FSB CPU and PC2700 DDR DIMMs, the memory frequency runs at 320 MHz (instead of 333 MHz) due to chipset limitations.

10