CD53 & CD50 Compact Disc Player
SAFETY WARNINGS
CAUTION!
Invisible laser radiation
when top cover is
removed.
CAUTION PERFORMING ADJUSTMENTS OR PROCEDURES OTHER THAN THOSE SPECIFIED HERE MAY RESULT IN HAZARDOUS EXPOSURE.
THE CD PLAYER SHOULD NOT BE REPAIRED BY ANYONE EXCEPT QUALIFIED SERVICE PERSONNEL.
SPECIFICATION
Power requirements | AC |
and fuse rating: | AC |
Power consumption | 20 W max 6 W standby |
Frequency response | 1 Hz - 20 kHz ± 0.25 dB |
Output level, unbalanced | 2.2 V RMS at 1kHz, 0 dB |
Balanced | 4.4 V RMS at 1kHz, 0dB |
Output impedance | 100 W , min load 1 kW |
Output balanced | 200 W , min load 1 kW |
Laser type | Semiconductor ALGaAs |
Wavelength | 790 nm ± 25 nm |
Light output (cw) | 0.18 mW typical |
Signal to noise ratio | better than 96dB’s |
Dynamic range | better than 96dB’s |
Number of channels | 2 |
Total harmonic distortion | < 0.0015% at 1 kHz, 0 dB |
Dimensions CD53 | 43 x 7 x 25 cm |
Dimentions CD50 | 43 x 6 x 23 cm |
Weight | 5 Kgs |
Class 1 Laser Product
OTHER FEATURES
1.
2.High precision DS digital to analogue conversion.
3.Advanced DEM (dynamic element matching) technology.
4.Low jitter filtered master clock
5.
6.16 program memory.
7.VFD display.
8.Shuffle function (random selection).
9.Repeat facility.
10.Intro scan facility.
11.
Note:
The specification and design are subject to change for improvements without notice.
NOTE
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations.
This equipment generates and can radiate radio frequency energy and if not installed and used in accordance with the instructions may cause interference to radio communications. However, there is no guarantee that interference will not occur in some instances. If this product causes interference to radio or television reception, which can be determined by turning the equipment off and on, try to correct this by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the radio or TV receiver.
Connect the equipment into a mains outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician.
3