Introduction and Installation
Introduction
Overview
The OMG-USB-DIO48provides six eight-bit ports that may be individually configured as inputs or outputs.
What’s Included
The OMG-USB-DIO48is shipped with the following items. If any of these items is missing or damaged, contact the supplier.
∙OMG-USB-DIO48 Adapter
∙Software CD
∙5V Power Supply
∙USB A to B Cable, Part number CA179
Industry Standard Relay Rack Cables and Options
∙Part number CA135 for Edge Connection
∙Part number CA167 for IDC Connection
∙Part number TB07-50 pin terminal block
Installation
For proper operation install software first. To install the software place the CD in your CD-ROM tray and the auto-run program will start. If auto-run is not available browse the CD and choose “index.htm”. Choose Install Software at the beginning of the CD. Select the Digital I/O software drivers and install SeaIO prior to installing hardware. After installing the software, connect the power adapter and USB cable to the OMG-USB-DIO48. In the event that the hardware is installed first, the “Found new hardware wizard” will request a driver disk. Insert the software CD and browse the SeaIO directory for the “SeaIO.inf” file. A complete installation of the SeaIO suite is recommended by running setup. When plugged in the device will light its enable LED once enumerated properly. Be sure to follow these steps to insure that the
OMG-USB-DIO48opens and enumerates properly.
