Omega Vehicle Security OMG-USB-232-4 manual Operating System Installation

Page 5

Installation

Installation

Operating System Installation

Choose Install Software at the beginning of the CD and install SeaCOM.

System Installation

The screen captures below are taken from a Windows 98 installation. Your particular operating system may differ slightly from what is shown based on your version of Windows.

The OMG-USB-232-4can be connected to any upstream type “A” port either at the PC host or an upstream hub. The OMG-USB-232-4is hot pluggable, meaning there is no need to power down your computer prior to installation.

Connect the OMG-USB-232-4to an upstream host or hub.

The New Hardware Found wizard will now proceed to locate the appropriate drivers. These drivers were installed during the SeaCOM software setup procedure. Once the drivers are found a new window will pop up indicating the installation of each of the four new ports.

If you view the system’s Device Manager, you should have new “COM” ports in the Ports (COM & LPT) Device Class. This is shown on the following page.

OMG-USB-232-4

Page 2

Image 5
Contents User’sGuide Mexico CanadaBenelux Czech RepublicContents What’s Included IntroductionOverview System Installation InstallationOperating System Installation Installation Electrical Interface Selection ConfigurationRS-232 DB-9 Male FeaturesTechnical Description Specifications Appendix a Troubleshooting Appendix B How To Get Assistance RS-232 Appendix C Electrical InterfaceAppendix D Asynchronous Communications Asynchronous Communications Bit DiagramCanadian Radio Interference Regulations Appendix E Compliance NoticesFederal Communications Commission Statement EMC Directive Statement EN60950 IEC950 ‘SafetyWARRANTY/DISCLAIMER Temperature