NETGEAR RM356 manual Verifying TCP/IP Properties, Configuring TCP/IP Properties Manually

Page 7

Configuring TCP/IP Properties Manually

If you choose not to configure your PC by DHCP, you must manually enter the following information in the TCP/IP Properties section of the Network Control Panel of your PC:

•IP address and subnet mask (choose from your assigned IP addresses or private IP addresses)

•Gateway (enter the IP address of the router)

•DNS server addresses (enter IP addresses provided by your ISP)

Verifying TCP/IP Properties

After your PC has been configured and rebooted, you can check the TCP/IP configuration using the Windows utility winipcfg.exe (for Windows NT® systems, use ipconfig.exe). From the “Start” button, open the Run window, type winipcfg, and click on “OK.”

Note: In addition to displaying the current TCP/IP properties, the winipcfg utility allows you to release and renew DHCP-assigned information without rebooting the PC.

Model RM356 Modem Router Installation Guide

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Page Front Panel of the Router Start Here Product IllustrationsFront Panel of the Model RM356 Modem Router Rear Panel Hardware InstallationRear Panel of the Model RM356 Modem Router Telephone Line Checklist Setup and PreparationISP Checklist Connecting the Router Network ChecklistUsing Private Internet Protocol IP Addresses Configuring TCP/IP Properties by Dhcp Configuring TCP/IPConfiguring Windows 95 for IP Networking Configuring TCP/IP PropertiesVerifying TCP/IP Properties Configuring TCP/IP Properties ManuallyClick on Finish Running FirstGearCommon Problems Accessing the InternetTrademarks M2-RM356NA-0
Related manuals
Manual 11 pages 14.52 Kb
Top Page Image Contents