NETGEAR CM212 manual Click OK twice and click Close Restart the computer

Page 11

Windows 98 or Me

1.Choose Settings>Control Panel from

the Start menu.

2.Double-click the Network icon.

3.Click the Configuration tab.

4.In the list of installed network components, select the TCP/IP entry for the computer’s Ethernet adapter or NIC.

5.Click Properties.

6.Click the IP Address tab.

7.If not selected, select Obtain an IP

address automatically.

8.Click the Gateway tab.

9.Select and remove any IP Gateway addresses that are listed.

10.Click OK and click OK again to close the Network control panel.

11.Restart the computer.

Windows 2000 or XP

1.Right-click My Network Place and choose

Properties.

2.Double-clickLocal Area Network Connection and click Properties.

3.Select Internet Protocol (TCP/IP) and click

Properties.

4.Select Obtain IP address automatically and

Obtain DNS server address automatically.

5.Click OK twice and click Close.

6.Restart the computer.

10

Image 11
Contents Page Introduction Installation OverviewCM212 Broadband Cable Modem What’s in the BoxEthernet Connection 1Prepare for InstallationUSB Connection Install the Cable Modem Cableusb Configure the Computer to Work with Modem Select CD-ROM Drives and click Next Page Windows Operating System Click OK twice and click Close Restart the computer Linux or Unix Operating System Macintosh Operating SystemTest the Connection Sharing Your Cable Internet with Multiple Computers USB or Ethernet light doesn’t light up TroubleshootingNo lights are lit on the modem Cable light doesn’t light upResetting TCP/IP Properties Windows Cable Modem System Requirements Modem SpecificationsEnvironmental Specifications Glossary of TermsVoluntary Control Council for Interference Vcci Statement Support Information Technical Support