NetComm NP643 manual Hardware Installation, Installation Check

Page 11

HARDWARE INSTALLATION

Installation Check

The LEDs of the Wireless PC Card Adapter are clearly visible and the status of the network link can be seen instantly:

1.Once the device is plugged in to the PC Card slot, the Power LED will light up indi- cating a normal status.

2.Once the driver is installed, the ACTIVE and POWER LED’s will start flashing. This means the adapter is starting to scan for other wireless devices within its range.

3.While the Wireless PC Card Adapter is connected and transmitting data to an Access Point or to another Wireless LAN station, the Active LED will start blinking.

NP643 IEEE 802.11g PC Card Adapter

11

YML786 Rev1

 

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Page Contents Introduction System Requirements Wireless Standards Wireless TerminologyWPA Getting to Know Your NP643 Package Contents Power PWR NP643 LED IndicatorsWindows 98se/ME/2000/XP Utility and Driver Installation Software InstallationIconDescription Installation Check Hardware InstallationLink Information Using the Wireless UtilityFieldDescription II. Configuration Tx Rate Preamble III. Advanced NP643IEEE 802.11g PC Card Adapter Default Key Select one of the 4 keys to use Network Key IV. Site Survey FieldDescription About Ascii Appendix a GlossaryBSS Dhcp CSMA/CACSMA/CD Essid DsssESS Ieee HEXPpdu PlcpSsid PsduWEP TCP/IPContact Information Appendix B Registration and Warranty InformationCopyright Information Customer Information Product Warranty Limitations of Warranty
Top Page Image Contents