NetComm PowerlineTM Series - Powerline Adapters 85Mbps Twin Pack
Important Safety Instructions
Please read these instructions carefully:
1.Unplug the NP285 Powerline Adapter from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning.
2.Do not use the NP285 Powerline Adapter near water.
3.The NP285 Powerline Adapter should never be placed near or over a radiator or heat source, or in a
4.The NP285 Powerline Adapter should be only connected to a 240Volt power circuit. If you are not sure of the type of power available, consult your dealer or local power company.
5.The NP285 Powerline Adapter relies on the building’s electrical installation for
6.For maximum performance we advise that you do not use an extension cord or multi power board between the adapter and the AC power source. Plug the NP285 Powerline Adapter directly into a 240V AC power point if possible.
7.Do not attempt to service the NP285 Powerline Adapter yourself, as opening or removing covers will expose you to dangerous electrical voltage points and will also void your product warranty.
8.Refer the product to a qualified service personnel for the following conditions:
•If liquid has been spilled into the product.
•If the product has been exposed to rain or water.
•If the product does not operate normally when the operating instructions are followed.
•If the product exhibits a distinct change in performance.
System Requirements
NP285 Powerline Adapter is compatible with all TCP/IP operating systems with Ethernet port. Drivers are not required for this adapter, but you can use the supplied Configuration Utility software to assign the network passwords.
Your computer must meet the following requirements in order to use the NP285 Powerline Adapter Configuration Utility: Windows Operating Systems:
•Windows 98SE, Windows Me, Windows 2000, Windows XP, Windows Vista or Windows 7 with Ethernet connection (for manual configuration). As above and MAC operating systems if using automatic plug and play configuration
•Pentium III 300 MHz MMX PC or greater
•At least 128MB hard disk space and memory
•
Note: | Your computer or the device to which you want to connect the NP285 Powerline Adapter must have an Ethernet port, i.e. a network card or a network Adapter. |
Getting to Know your NP285
The NP285 Powerline Adapter has three lights indicator (LEDs) and an
PWR:Lights up when connected to AC power supply.
ETHERNET: This is the connection point for connecting it to a computer or other devices with Ethernet port.
YML��� | Powerline Adapters User Guide |
www.netcomm.com.au | � |