Installation
The 10/100Mbps PCI bus Fast Ethernet Card requires Hardware installation first, then BIOS and Driver installation.
Step 1: Hardware Installation
1.Turn off your computer and disconnect the power cable.
2.Remove the cover from your computer.
Please check your computer’s documentation (particularly your warranty details) for instructions and warnings regarding the removal of covers or installation of
3.Select an empty PCI slot and remove the appropriate expansion slot cover from the computer.
4.Insert the card into the PCI slot and secure with a screw in the backplane.
5.If supplied connect the WOL (wake on LAN) cable to the WOL connector on the card and on your motherboard.
6.Replace the computer’s cover.
7.Insert one end of the network cable into the socket on the PCI Network Card.
NP1100 10/100Mbps PCI Bus Fast Ethernet Card | 3 |
YML567 Rev2 |
|