Use the screws supplied to screw the case to the panel.
The unit and all connectors are waterproof. The unit screws to a vertical panel with the connectors facing down. Form the cables into loops below the unit so that any condensation will drip off.
Connect up to four (4) USB accessories. Each USB accessory can be powered from the USB hub by the USB port 5 V supply (500 mA maximum) or the accessory must have its own power supply.
Connect the USB hub type B connector to a type A USB port in the Northstar 8000i System, either port on the processor can be used, or connect to a port on another USB hub.
Connect to supplied power cable making sure a 5 Amp fuse is used
A | Red | Battery Positive |
|
|
|
|
|
B | Black | Battery Negative |
|
|
|
|
|
C | Green / Yellow stripe | Ships Ground |
|
| or Brown |
|
|
|
|
|
|
D | Fuse | Use a 5 Amp fuse or breaker |
|
|
|
|
|
E | Battery | 12 V DC or 24 V DC Nominal |
|
|
|
|
|
| Northstar 8000i 4 Port USB Hub Installation Manual | 9 | |