NuTone installation instructions Automatic Heat Sensor, Model AHS-200

®

INSTALLATION INSTRUCTIONS

READ & SAVE THESE INSTRUCTIONS!

Automatic Heat Sensor

MODEL: AHS-200

For use with NuTone Attic Ventilators

The NuTone Model AHS-200 is a 200°F heat sensor and is intended to be installed in the attic and connected into the power line of a NuTone Attic Ventilator. In the event the attic temperature surrounding the heat sensor reaches 200°F (for any reason, including fire), the unit will interrupt power to the ventilator and then will be turned off.

1.Located the heat sensor near the Attic Ventilator thermostat so that it is up-roof from the ventilator and thermostat.

2.Mount the heat sensor on the side of a roof rafter so that it's pointing down toward the living area of the home.

MODEL AHS-200

THERMOSTAT

TO 120vAC,

60 Hz

	AHS-200 BOX	THERMOSTAT BOX
HEAT
SENSOR	WIRE
	CONNECTOR			VENTILATOR
				MOTOR
	GREEN GROUND
			THERMOSTAT
	SCREW		WIRE
	WIRE
	CONNECTORS		CONNECTOR
	ATTIC
	LIVING AREA
	ON/OFF SWITCH

120vAC, 60 Hz POWER, PLUG GROUND