MOUNTING
Gimbal Mount Model (ST8-G)
1.Install the gimbal mounting bracket with three screws (cus- tomer supplied) according to the mounting hole dimensions shown below. NOTE: Verify the TATTLETALE®s rotation clearance (see Dimensions, page 1).
2.Attach the TATTLETALE® to the gimbal bracket with the washer and mounting bracket knobs.
TATTLETALE®
Washers (2)
Gimbal Mounting Bracket Hole Dimensions
(89 mm)
Customer Supplied
Bracket Mounting
Screws (3)
1 in. | Gimbal |
(25 mm) | Bracket |
|
|
(44 mm)
Mounting Bracket
9/64 in. (4 mm)Knobs (2) diameter 3 places
Panel Mount Model (ST8-F)
1.Cut a hole in the panel according to the mounting hole dimen- sions shown below.
2.Install the flush mount mounting bracket on the TATTLETALE®.
3.Insert the TATTLETALE® into the hole through the front of the panel.
4.Install the four
Mounting Holes
Panel Mounting Hole Dimensions
(135 mm)
TATTLETALE®
Flushmount
Bracket
(137 mm)
5/32 in. |
| |||
(4 mm) |
|
| (119 mm) |
|
|
|
| ||
Typical |
|
|
|
|
|
|
|
| |
4 places |
|
|
|
|
Bracket Mounting
Screws (2)
Mounting
Screws (4)
APPLYING PREPRINTED LABELS
Preprinted label are supplied with the TATTLETALE®. These labels are precut, pressure sensitive and when properly applied are permanent. To insure proper label application perform the following steps:
1.Be sure the TATTLETALE®s faceplate is clean and free of oil.
2.Peel one label at a time and position on the faceplate in the box which matches the input sensor position.
3.Before pressing down, be sure label is correctly placed.
4.Press firmly on the label, and leave untouched for
several hours.