MultiModem Quick Start Guide
Installing your Modem
Installing your modem requires you to open your system. Please consult your system manual in addition to the following instructions.
Prerequiste: For EDGE models only, you must have the SIM chip from your wireless service provider before installing you MultiModem.
MTCBA-C
MTCBA-E
1.Turn off your system and unplug it. Failure to do so may result in damage to both the MultiModem and your system. Do not turn on the system until the instructions tell you to do so.
2.Remove the cover from your system as instructed in the system manual.
3.Select an empty PCI expansion slot. Remove the expansion slot cover and save the retaining screw.
4.Before handling the MultiModem, discharge static in your body by touching a metal piece of the system chassis. Carefully remove the MultiModem from its antistatic bag, handling it only by the mounting bracket and edges. Do not touch the
5.For EDGE units only. Orient the SIM to match the marking on the SIM compartment, the notch part of the SIM should be facing the mounting bracket. Insert the SIM into its receptacle.
6.When installing the MultiModem, ensure that the antenna SMA connector is facing out of the system.
7.Place the MultiModem directly above the expansion slot and gently, but firmly, push it into the connector until the card’s retaining bracket is flush against the system chassis.
8.Fasten the retaining bracket to the system chassis with the screw saved in step 3.
9.Replace the system cover.
10.Attach the antenna to the threaded SMA connector on the mounting bracket.
11.Power up the system.
5 |