PowerView PVM Series Gages | Murphy instruction

0710178

06-27-07 Section 78

PowerView™ PVM Series Gages

Features

•For modern electronic engines and equipment using SAE J1939 Controller Area Network

•Display SAE J1939 parameters broadcast by the PowerView system.

•Cutting-edge, stepper motor technology and robust functionality combined

•Microprocessor driven for high accuracy

•Simple installation and wiring design

The PowerView PVM Series gages are intelligent gages designed to display easy-to-read information transmitted by the PowerView. The PVM gages communicate with the PowerView via a single RS485 twisted pair MODBUS® RTU serial link. The gages can be daisy-chained using quick-connect harnesses.

The major feature of the PVM gages is their balance between design and functionality. These modern gages offer a selection of bezel styles and colors shown on page 3 of this document.

The PVM gages also include features such as a smooth stepper motor operation for the 270° sweep pointer, an environmentally sealed case with two Amp Mini Universal Mate-N-Lok connectors molded into the casing, and green LED back lighting. They are available for standard 2-1;16 in. (52 mm) and 3-3/8 in. (86 mm) diameter hole sizes. In addition their plastic cases incorporate a “D” shape allowing panel cutouts that eliminate gage rotation during installation.

PVM20 Series Models

• PVM20-A = Engine Oil Pressure	• PVM20-J = Percent Fuel Level
• PVM20-B = Coolant Temperature	• PVM20-K = Boost Pressure
• PVM20-C = Voltmeter	• PVM20-L = Exhaust Gas Temperature
• PVM20-D = Percent Load at current RPM	• PVM20-M = Intake Manifold Temperature
• PVM20-E = Transmission Oil Pressure	• PVM20-N = Auxiliary Temperature
• PVM20-F = Transmission Oil Temperature	• PVM20-P = Auxiliary Pressure
• PVM20-G = Engine Oil Temperature	• PVM20-T = Tachometer
• PVM20-H = Hydraulic Oil Temperature

PVM35 Series Models

•PVM35-T = Tachometer

•PVM35-S = Speedometer

In order to consistently bring you the highest quality, full featured products, we reserve the right to change our specifications and designs at any time. MURPHY, the Murphy logo, MurphyLink™ and PowerView™ are registered and/or common law trademarks of Murphy Industries, Inc. This document, including textual matter and illustrations, is copyright protected by Murphy Industries, Inc., with all rights reserved. (c) 2007 Murphy Industries, Inc.