Connecting to Your Network | MicroNet Technology SP2515 SERIES

5.Carefully insert the Fiber Adapter into the chosen slot and press firmly with proper push to ensure it is fully seated in the slot.

6.Secure the Fiber Adapter with the screw you saved in step 4.

7.Replace the PC cover.

8.Proceed to “Connecting to Your Network” section.

2.3 Connecting to Your Network

This section describes how to connect the Fiber Adapter to a 100 Mbps fiber-based Ethernet network, which contributes to its optimal performance.

1.Remove the protective covers from the Fiber Adapter’s connector.

2.R Prepare a network cable with corresponding connectors for the two end devices, one end to the Fiber Adapter and the other to a 100Mbps fiber port on the network hub or switch.

3.Connect the network cable to the connector on the Fiber Adapter.

4.Connect the other end of the network cable to a 100BASE-FX hub or a switch.

5.When the cable is properly connected to two end devices, turn on the power to the PC.

6.Check the LNK (Link) LED. The LED will come on when the Fiber Adapter is receiving a good link signal from the connected device, a hub or switch.

7.Proceed to next section for installing the network driver.

2.4 Drivers and Utilities Diskette

The [Divers and Utilities] diskette contains all the popular operating system drivers.

Novell NetWare (client /server) Windows NT 3.5, NT4.0 Windows 95/98/2000

Microsoft Client (NDIS 2.0 DOS/OS2) Windows For Workgroup 3.11

….and so on

2.5Software Installation

Please refer to “Quick Installation Guide”