Cascading, Configuration | Lightwave Communications USB-Wizard

CASCADING

The USB Wizard can be cascaded as shown in Fig. 6 below. If USB Wizard switches are being cascaded, configure the dip-switches accordingly (see Tables 1 and 2 on page 8).

Configuration

All units are configured using the 6-position dip switch (located on the front of each unit) according to the tables on page 8 (1 & 2).

Cascaded Installation

a.Configure each dip switch as per the tables on page 8 before proceeding.

b.Using the 15HD video cable ends of a USBVEXT-xx-MM cable, connect the USB Wizard slave's MONITOR port to the master’s VIDEO 1 port.

c.Using the USB ends of the same USBVEXT-xx-MM cable, connect one of the USB slave’s USB DEVICES ports to the master’s CPU 1 port.

Note: Only one of the two ports labeled DEVICES on a slave needs to be used in order for cascading to work.

d.Repeat step b. & c. for each additional slave, keeping in mind that each slave will connect to the next available master’s port (i.e. Slave #2 to master’s VIDEO 2 & CPU 2, etc.) See Fig. 7 on page 8.

e.With a RMT extension cable, connect the master’s DAISY OUT port to slave #2’s DAISY IN port. Then connect slave #2’s DAISY OUT to slave #3's DAISY IN. Continue until all slaves are connected together.

U S B U S BU S B C P U C P UC P U

U S BU S B C P UC P U

U S B C P U

U S B - V E X T - Ux xS MB M- V E X T - Ux xS MB M- V E X T - x x M M

USB Wizard

( s l a v e u n istl a1v)		( s l a v e u n i t
R E X T -(S R - x x ReE XuTn- SiRt- x2x)

	U S B V E X T - x x - M M

U S B V E X T - x x - M

				M
			x-M
		T-x
	EX
BV
US

U S B C P U

R E X T - S R - x x

USB Wizard

( m a s t e r u n i t )

USBVEXT

U S B

C P U

Lightwave Communications USB-Wizard Cascading, Configuration, Cascaded Installation, X T S R x