MGE UPS Systems SNMP 10BT user manual Installation, Setup

Page 6

2. Installation

2.1 Setup

Position of the jumper for network-parameter selection 6 :

1

Personalised network parameters

2

(default position)

3

 

1

2Factory-set network parameters

The SNMP communication card may be installed in either:

A UPS (see figure 1).

A MultiSlot module (see figure 2).

The front of the card must be secured to the device frame using the two screws provided. It is not necessary to de- energise the device before inserting the card.

Figure 1: example of an installation in a UPS

UPS

U-Talk

Figure 2: example of an installation in a MultiSlot module

MultiSlot

 

UPS

 

U-Talk

 

 

Us/Out/Ausg

 

1

10A/250V

 

 

2

Ue/In/Eing

I max 3.4A

Page 6 - 51029486EN/AA

Image 6
Contents Snmp 10BT communication card Environment Pictogram symbolsIntroduction Recycling of packagingContents Check on contents PresentationStorage Functions OverviewKey Installation SetupCard identification Special case for Galaxy PW UPSsEthernet connections Straight 10 Base-T cableCrossover 10 Base-T cable MAC address Default IP address Other default network parametersOperation Return to default network parameters Reset buttonPersonalised network parameters Troubleshooting Appendices GlossaryUPS BUS Index