Cary Audio Design CAD 200, CAD 500 owner manual Specifications

SPECIFICATIONS ___________________________________________________

This section describes the basic specifications of the CAD 500 MB or CAD 200 power amplifiers at the time of printing. Specifications are subject to change without notice or obligation. When the following cautionary terms are used in this manual, these definitions apply:

WARNING

Electrical hazard! Misuse or failure to follow instructions properly may result in personal injury or death!

CAUTION

No risk or personal injury; however, misuse or failure to follow instructions may result in damage to equipment.

NOTE

No risk of personal injury or equipment damage; however, misuse or failure to follow instructions may prevent proper performance of the equipment.

........................................................................................................................................................................................................................

RATED POWER OUTPUT
CAD 500 MB	500 watts @ 8 ohms, 1,000 watts @ 4 ohms, Class A/B
CAD 200	200 watts/channel - 8 ohms, Class A/B x 2
	350 watts/channel - 4 ohms x 2

........................................................................................................................................................................................................................

DAMPING FACTOR>100 @ 8 ohms

........................................................................................................................................................................................................................

PEAK CURRENT	CAD 500 MB - 70 amps
	CAD 200 - 35 amps

........................................................................................................................................................................................................................

FREQUENCY RESPONSE	10 to 50 kHz +/-0.1 dB
	-3 dB @ 200 kHz

........................................................................................................................................................................................................................

INPUT POWER REQUIREMENTS 117 VAC 50/60 Hz or 234 VAC 50/60 Hz, by market

........................................................................................................................................................................................................................

POWER CONSUMPTION	255/155/115/90/125 Watts – Idling with no signal input
	2500/1000, All channels, 8-ohm load, full power

........................................................................................................................................................................................................................

INPUT IMPEDANCE44k ohms - Single-ended RCA inputs

91k ohms - Balanced XLR inputs

........................................................................................................................................................................................................................

OUTPUT IMPEDANCE 4 to 16 ohms rated speaker impedance

........................................................................................................................................................................................................................

GAIN 27 dB

........................................................................................................................................................................................................................

THD< 0.05 %, 20 Hz-20 kHz

........................................................................................................................................................................................................................

NOISE > 100 dB below rated output, A-weighted

6