Cary Audio Design SLP 03 owner manual Controls and Displays, Front Panel

Page 10

CONTROLS AND DISPLAYS

FRONT PANEL

1.POWER

•Press once to turn the power ON.

•Press again to turn the power OFF. The amplifier will enter STANDBY and the blue POWER LED will light.

2.HEADPHONE JACK

•This jack is used to listen to headphones.

3.SOURCE SELECTOR

•The input source is selected by pressing the respective buttons.

4.ALPHANUMERIC Display

•This thirteen-character display provides a wide range of information concerning the operation of the SLP 03. The information displayed depends on what the SLP 03 is doing.

•The information displayed is summarized below:

Normal Operation: Displays the selected input name and volume setting.

Balance Mode: This shows the direction (L or R) and magnitude of the balance offset, from channel to channel.

5.VOLUME

•Use the volume control to adjust the listening level.

6.POWER INDICATOR (Standby)

•This indicator lights when the amplifier is switched into standby mode.

9

Page 9 Page 11
Image 10
Page 9 Page 11
Contents SLP Table of Contents Important Safety Instructions Important Safety Instructions FCC Information for User Thank YOU WelcomeProduct Overview Unpacking and Installation UnpackingSpecifications Basic SpecificationsConnections Switching onOperation Checking ConnectionsControls and Displays Front PanelRear Panel Balanced InputsDC Trigger Output Terminals Remote Control Factory Service Service and CareCare and Cleaning NON-WARRANTY RepairsUnited States Limited Warranty Warranty DisclaimerCary Audio Design
Top Page Image Contents