MaxTech XT5861 user manual Monitor Controls and LEDs

•Plug the 15-pin male connector on the video cable into the output connector on the rear of your computer system. The video output connector on your computer may be either in a location similar to Figure 2-2 or on an expansion board. Secure the cable to the computer using the thumbscrews on the 15-pin connector.

•Attach the power cord to the monitor and plug it into an AC outlet.

•The monitor is now ready for use.

Section 3 - Monitor Controls and LEDs

Figure 3-1 Controls and LEDs

A

1

B

2

3 4 5 6 7 8 9 10

1.Power Indicators: LEDs A and B indicate the state of the Monitor.

•LED A On (green) Normal operations.

•LED A flashing DPMS (Display Power Management Signaling) “STAND-BY” mode.

•LED B On (orange) DPMS “OFF” mode.

2.Power Switch: Push to turn the monitor ON, push again to turn the monitor OFF.

3.Trapezoid: Adjusts the angle of the sides of the display to make the display rectangular.

4.Pincushion: Adjusts the curvature of the sides of the display to make the sides straight.

5.Vertical-Position:Adjusts the vertical position

4