LOREX Technology ACC-HDB80 owner manual Installation, Typical Configuration

INSTALLATION:

Back of Unit

IDE Sub Output (40 pin)

12V DC Power

Adapter Connection

Power Switch

1.Connect the 40 pin interface cable to the IDE Sub output on the External IDE Bay Unit. Connect the other end of this cable to the IDE Sub input on the back of the DVR or DVR combo unit

2.Follow the procedure in the DVR or DVR Combo owner’s manual for installing the HDD unit.

Important Note: If you are using your own HDD, please set the jumper to SLAVE. Refer to the

instructions included with your HDD for more information. Depending on the model purchased, an HDD may or may not be included.

3.Plug in the 12V DC power adapter into an AC outlet, and turn the power switch ON

4.When you start-up your DVR or DVR Combo the system will automatically detect the MASTER drive only. For the system to detect both the MASTER and SLAVE, you will need to go into the MAIN MENU CONTROL and select the HDD/REC SET and set the parameters to activate the HDD slave.

Note: These steps are outlined in the MAIN MENU CONTROL section of the DVR or DVR Combo’s Owner’s Manual

When the MASTER HDD becomes FULL during recording, the SLAVE HDD becomes the active drive, receiving the earliest recorded data from the MASTER HDD. Therefore, data is not lost, as it gets transferred to the SLAVE HDD.

TYPICAL CONFIGURATION:

Back of a 21” DVR Combo 40 pin Interface cable

CH1	CH3				RS-232				USB
		SENSOR INPUT							SENSOR
CH2	CH4								OUTPUT
POWER
MAIN S/W	+	-	+	-	+ -	+	-		+ -
VIDEO INPUT								SLAVE	MONITOR
CH1	CH3			AUDIO INPUT
								OUT	OUT	IDE-SUB
AC INPUT									VIDEO
	1				2	3		4
CH2	CH4
									AUDIO
AC100-240V,50/60Hz

Back of HDD Bay