Cary Audio Design C 306 owner manual FCC Information for User

Page 5

IMPORTANT SAFETY INSTRUCTIONS

26.FCC INFORMATION FOR USER:

CAUTION: ANY changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from where the receiver is connected.

27.OUTDOOR ANTENNA INSTALLATION/SAFE ANTENNA AND CABLE CONNECTION: If an outside antenna or cable system is connected to the equipment, be sure the antenna or cable system is grounded so as to provide protection against built up static charges and voltage surges, Section 810 of the national Electrical Code, ANSI/NFP A70 (in Canada, part 1 of the Canadian Electrical Code) provides information with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna discharge unit, size of grounding conductors, location of antenna discharge unit, connection to grounding electrodes and requirements for the grounding electrode.

Keep Antenna Clear of High Voltage Power Lines or Circuits

An outside antenna system should be located well away from power lines, electric light or power circuits and where it will never come into contact with these power sources if it should happen to fall. When installing an outside antenna, extreme care should be taken to avoid touching power lines, circuits or other power sources as this could be fatal. Because of the hazards involved, antenna installation should be left to a professional.

Image 5
Contents 306 Reference Preamplifier Important Safety Instructions Important Safety Instructions FCC Information for User Alphanumeric Display Front PanelDisplay indicator Rear Panel Power Input ACAnalog Record Output Jack RCA Unbalanced IR Input JackSINGLE-ENDED Inputs Balanced InputsBalanced Main Outputs SINGLE-ENDED Main OutputsMain-R/C Remote ControlSub-R/C Specifications Installation Customizing Your C Setup OverviewMenu System RenameSelect a Mute Level Changing Input NamesReset Defaults Setting a Volume Level ModeNormal Operation OperationBalance Function of PolarityService and Care United States Limited Warranty Cary Audio Design