Metra Electronics ESCORT ZX2, 99-5720 installation instructions Fig. a, Mounting Kit

ALL VEHICLES

1

Disconnect the negative battery terminal to prevent an accidental short circuit. Reach under the driver's side dash and unclip the temperature control cable. Using Metra's 86-5618,pull the factory radio/climate control panel from the dash. Disconnect the switch power harness, antenna plug, radio/speaker power harnesses and vacuum hose harness.

3

Fig. A

Fig. B

Fig. D

Fig. C

Turn the factory climate control dials into a vertical position and pull the dials off. (see Fig. A). Unclip the vent control switch and remove. Remove (2) torx-head screws securing the temperature control switch and fan speed control switch and remove. (see Fig. B). Mount the switches to the back of the Integrated Mounting Kit with the same torx-head screws.(see Fig. C). Holding the climate control dials in a vertical position, insert the dials onto the posts of the mounted switches and secure. (see Fig. D)

2

"C"

"A"

"B"

(BACK VIEW OF INTEGRATED CONTROL PANEL)

45

Fig. A

¾"

Turn the integrated control panel over and disconnect the vent control harness ("A"), fan speed control harness ("B"), and defroster harness ("C"). Unclip the main switch harness from the side of the factory unit. (This harness connects the fan speed control harness, vent control harness and defroster harness).

Cut and remove the shaded portion of the		Make all	wiring connections to the
		Integrated	Mounting Kit	and snap the
sub-dash lip.	(see Fig. A)
		assembly into the sub-dash. Reach under

the driver's side dash and re-attach the temperature control cable.

1 2