Liebert micro smart switch user manual Dual Input

Configuration 3

This configuration shows the use of a Micro SmartSwitch with 2-line cord devices. In this configuration, a server is connected to each of the four segments

of the Micro SmartSwitch.
Note: Each segment can	L6-30P
accommodate a maximum cur-				Load
rent draw of 10A, so the individ-	~ A	DP	1
				Load
ual load connected to it must not			2
	Dual Input
exceed 10A or the circuit	~ B	U	3	Load
			4
breaker will trip.
~A: AC Input A	L6-30P			Load
	200-240 VAC
~B: AC Input B
1,2,3,4: Load segments on the	L6-30P
Micro SmartSwitch
	~ A	DP	1
				Load
			2
Load: Any server, storage, or	Dual Input
	~ B	U	3	Load
other equipment connected to			4
the Micro SmartSwitch	L6-30P

200-240 VAC

Configuration 4

If your facility does not have a centralized Uninterruptible Power System, then the following configuration will provide maximum redundancy in a rack environ- ment. The diagram below shows how to use three Micro SmartSwitchs, each con- nected to a UPS and a server.

Note: Each segment can accommodate a maximum current draw of 10A, so the individual load connected to it must not exceed 10A or the circuit breaker will trip.

~A: AC Input A

~B: AC Input B

Load: Any server, storage, or other equipment connected to the Micro SmartSwitch

DUAL INPUT

~ A	P		Load
	D	UPS
~ B
	U
~ A	P		Load
	D	UPS
~ B	U
~ A	P		Load
	D	UPS
~ B
	U
L6-30P		200-240 VAC

DISCONTINUED

PRODUCT