krossfour EasyStart
Connections and Setup
1.Connect a composite or
2.Connect the main out (composite or
3.Connect monitor out (composite) located on the front panel, to the video monitor you will use for cueing video sources.
4.Select NTSC or PAL format (USA standard is NTSC, PAL is usually Europe) by setting the switch on the rear panel to the proper setting.
5.
Selecting an Input for a Channel
Located in the center area of the krossfour’s top panel are 2 groups of buttons. Each group is labeled 1, 2, 3, and 4. These button groups are positioned at each side of the cross- fader…
1.Simply press the buttons for the corresponding video sources that you want to place on each channel or side of the
Note: The same video source can be used for both channels at the same time – more about this later.
Note: When a video source is selected for an input that is not connected, you will see a
Note: When an input button is pressed twice it will blink, and you will see a black screen.
Selecting a Source to Monitor
Located on the top panel of the krossfour is a row of buttons labeled 1, 2, 3, 4, and OUT. This is the Monitor Select section. When a video monitor is connected to the monitor output (located on the front panel), any of the 4 inputs or the main output can be viewed, allowing you to “cue” up to specific points of a video source…
1.Press the button for the corresponding video source that you want to monitor in the monitor select section. When a source is selected the button will glow red.
Note: The monitor out can be treated as a 3rd output for the krossfour, if OUT is selected in the monitor select section.
Holding or Freezing a Source
Located below each of the two input groups for each channel is a HOLD button. This will freeze any incoming source on the specified channel…
1.Press the HOLD button on either channel when a source is being viewed through it. The image will freeze and the button will glow red. To release the frozen image press the button again.
Note: Tapping the HOLD button to match an audio source tempo will create
2