LaCie 2big USB 3.0 manual Changing the RAID Mode

Changing the RAID Mode

CAUTION:

•Reformatting the 2big USB 3.0 is the last step for modifying the RAID. Please back up all data before following the steps below.

•The two disk trays must be in place before the RAID mode can be modified.

Note: See the User Manual for information on RAID modes.

1.Unmount the 2big USB 3.0 volumes from your computer and disconnect the interface cable.

2.The 2big USB 3.0 must be turned on to change the level of RAID. Attach the power cable if it is disconnected. Switch on the 2big USB 3.0 by pressing the front LED button. The front LED will blink as the RAID boots. It will become solid blue when ready.

3.Use the 2-in-1 tool to move the RAID selection switch to the left (RAID 0 - FAST), center (JBOD), or right (RAID 1 - SAFE).

4.Use the 2-in-1 tool to push the RAID confirmation button to validate the level of RAID. The front LED will blink as the 2big USB 3.0 rebuilds the level of RAID you have chosen. When the front LED turns solid blue, move to step 5.

DESIGNED BY NEIL POULTON

Fast JBOD Safe

Confirm

3.0USB

5.Reattach the interface cable to your computer and format the RAID. Please refer to the User Manual for more information on formatting.