LevelOne WBR-3403TX user manual IPSec proposal

Page 53

IPSec proposal.

Life time

The unit of life time is based on the value of Life Time Unit. If the value of unit is second, the value of life time represents the life time of dedicated VPN tunnel between both end gateways. Its value ranges from 300 seconds to 172,800 seconds. If the value of unit is KB, the value of life time represents the maximum allowable amount of transmitted packets through the dedicated VPN tunnel between both end gateways for. Its value ranges from 20,480 KBs to 2,147,483,647 KBs.

Life time unit

There are two units can be selected: second and KB.

Proposal ID

The identifier of IPSec proposal can be chosen for adding the proposal to the dedicated tunnel. There are total ten proposals can be set in the proposal pool. At most only four proposals from the pool can be applied to the dedicated tunnel as shown in the proposal index list.

Function of Buttons

Add to button: Click it to add the chosen proposal indicated by proposal ID to IPSec Proposal index list. The proposals in the index list will be used in phase 2 of IKE negotiation for getting the IPSec SA of dedicated tunnel.

53

Image 53

Contents LevelOne Trademarks CopyrightCE Declaration of Conformity FCC Interference StatementTable of Contents Firmware Upgrade Functions and Features Virtual Server supported Universal Plug and Play UPnP supportedUser-Definable Application Sensing Tunnel DMZ Host supportedPanel Layout Packing List802.1X supported Front PanelWlan Reset Rear Panel Procedure for Hardware InstallationDecide where to place your Wireless Broadband Router Setup WAN connection Setup LAN connectionConnecting this product with your printer Power onInstall the Software into Your Computers Make Correct Network Settings of Your ComputerPage Page Page Start-up and Log Configuring LevelOne WBR-3403TXStatus Wizard Page Basic Setting Primary Setup WAN Type, Virtual Computers Press Change Dynamic IP Address Static IP AddressPptp PPP over EthernetPage Virtual Computers Press More Dhcp ServerPage Wireless Setting, and 802.1X setting Encryption Key Length 802.1XRadius Server Radius Shared KeyChange Password Forwarding Rules Virtual Server Special AP Miscellaneous Items UPnP SettingIP Address of DMZ Host Non-standard FTP portSecurity Settings Packet Filter Example Inbound FilterThey can do everything block nothing Others are all blocked Example Page Domain Filter Example URL Blocking URL Blocking EnablePage MAC Address Control IP Address Control tableMAC Address ∙ Max. number of tunnels item VPN setting∙ Tunnel name ∙ MethodFunction of Buttons ∙VPN Settings IKEBasic setup Local subnet Remote subnet Local netmaskRemote netmask Remote gateway∙VPN Settings Set IKE Proposal Encapsulation protocol ∙VPN Settings -Set IPSec ProposalIPSec Proposal index IPSec proposal Discard Ping from WAN side Remote Administrator Host/PortAdministrator Time-out Advanced Setting Get Date and Time by NTP Protocol System TimeTime Server Time ZoneSystem Log Mail Alert EnableIP Address for Syslog Smtp Server IP and PortMail Subject Dynamic DNSExample Enable Snmp Snmp SettingGet Community Set CommunityPage Routing Table Page Toolbox You can View system log by clicking the View Log button Firmware Upgrade Reboot Backup SettingReset to default Domain Name or IP address for Ping Test MAC Address for Wake-on-LANPrint Server Configuring on Windows 95/98 PlatformsPage Page Configuring on Windows NT Platforms Configuring on Windows 2000 and XP Platforms Select Ports page, Click Add Port… Page Select Custom, then click Settings… Page Apply your settings Page Configuring on Unix based Platforms Install TCP/IP Protocol into Your PC Appendix a TCP/IP Configuration for Windows 95/98Set TCP/IP Protocol for Working with NAT Router Page Page Don’t input any value in the Gateway tab Choose Disable DNS in the DNS Configuration tab Page