Lantronix LFH8-M, LFH4-M manual Power LED, Collision LED

Page 12

3.1 Power LED

The green LED on the front panel labeled PWR is used to indicate that the LFH hub is receiving power and is turned on. If the LED is off, check the following to isolate the problem:

▼Make sure the power cord is properly connected to the power outlet and is properly inserted into the power connection on the LFH hub

▼Determine whether or not the outlet is functional by plugging another device into the receptacle

3.2 Collision LED

The yellow collision LED is located on the front panel and is labeled COL. This indicates that two (or more) stations on the network attempted to transmit at the same time. When a collision occurs, all of the stations involved will recognize the collision, wait a random amount of time, and re-transmit. Collisions are normal in Ethernet networks, though excessive collisions may indicate that your network is overly congested. Other network problems can cause excessive colli- sions, including:

▼Workstation cables exceeding the maximum length of 100 meters

▼A total network diameter exceeding the maximum 205 meters

▼Faulty Fast Ethernet adapters or other equipment on the network

11

Page 11 Page 13
Image 12
Page 11 Page 13
Contents LFH4-M/LFH8-M Table of Contents Product Introduction Features Product Specifications Packing Checklist Planning 100BASE-TX NetworksInstallation LFH4-M 100BASE-TX Network ExampleLFH4-M Front Panel Mounting Connecting the LFH Hub LFH8-MLFH4-M Front Panel LED Indicators Power LED Collision LEDLink/Activity LEDs Partition LEDSystem Status LEDs Limited Warranty Page Declaration of Conformity Page Part no -142 Rev.A
Top Page Image Contents